❗ Autotuner update for Bosch EDC16C37 ❗
Autotuner is now able to perform the following operations:
✅ Bench Read
✅ Bench Write
On the following vehicles:
✅ Chevrolet - 6.6 Duramax - 360hp
⭐ Autotuner Master
⭐ Autotuner Slave
Printable View
❗ Autotuner update for Bosch EDC16C37 ❗
Autotuner is now able to perform the following operations:
✅ Bench Read
✅ Bench Write
On the following vehicles:
✅ Chevrolet - 6.6 Duramax - 360hp
⭐ Autotuner Master
⭐ Autotuner Slave
⭐️❗️ PCMflash update! ❗️⭐️
Added features, more ECUs and TCUs supported in PCMflash!
✅ Module 12 now supports writing and chekcsumm correction for Continental LuK-UDCT ECU in Honda vehicles.
✅ Module 28 supports ME17.9.7 with the diagnostic protocol, working via CAN-bus.
✅ SIM2K-141.1 is now supported in Module 30, reading, writing and checksum corrections.
✅ Module 35 now supports the eight-speed transmission Aisin TCU with 70F4019, used in Lexus LX570. Writing and checksum corrections.
✅ Fixed the writing issue in Module 41.
✅ Module 51 supports MED17.8.10 for Chery with F4J16 engine.
✅ Module 53 has added the support of the robotiс TCU SIM2K-305.
✅ Continental LuK-UDCT for Honda is now supported in Module 58 in service mode. Reading, FLASH and EEPROM writing, FLASH checksum correction.
✅ ME9.7 is supported in Module 69 with reading, writing and checksum corrections.
✅ Module 76 supports SIM2K-305 in test stage with a robotiс TCU. Reading (with direct connection to the ECU), writing (after unlocking with module 53), checksum correction.
✅ PSG16, EEPROM 95080, is now supported in module 77. The list of supportted checksum corrections has been extended.
✅ Etc.
PCMflash
❗️Two new MD Flasher licenses are up for pre-order!❗️
The modules allow working via OBD or on the bench with SRS ECUs with TriCore Aurix TC2xx in Hyundai/Kia [81] and Nissan/Infinity [82].
➡️ The module supports:
✅ Identification
✅ Error reading
✅ Error erasing
✅ DFLASH reading
✅ DFLASH writing
❗️The activation files will be sent after 30.08.2021
Not all software versions are supported. If the software versions are not supported by this license, please contact the support on this portal. Please also include a photo of the ECU and the full information regarding CFLASH, DFLASH, UCB, OTP, etc.
➡️ PRE-ORDER - Licence 81 - Hyundai/Kia SRS TriCore Aurix TC2xx OBDII
➡️ PRE-ORDER - Licence 82 - Nissan/Infinity SRS TriCore Aurix TC2xx OBDII
⭐️ ❗️ PCMflash vacation! ❗️⭐️
➡️ The PCMflash developer is taking a vacation off work from August 17th to 31st, inclusive. You will be able to get activations faster on August 16th and September 1st onward.
During the developer's days off work the activations and support can be delayed up to 3 days. Feel free to plan your purchases accordingly.
⭐️ PCMflash
❗ bFlash Update V2108A ❗
The bFlash team presents its advanced logging solution exclusively for VAG SIMOS18.1, SIMOS18.10 and PORSCHE SDI21.
This solution is intented to offer you the possibility to load your own logging configuration in bLog.
The proprietary patch allows high-frequency data acquisition. It can be applied via OBD or in BOOT, depending on the methods supported by the OEM ECU.
❓ How fast is it?
You can log each variable at a rate of 30-50Hz depending on your configuration.
❓ How do I activate this function?
You have to patch the ECU and your A2L once.
❓ Does bFlash provide the definitions?
No, you will need to define your own A2L to work with this feature.
❓ Do I really have access to everything?
Yes all the RAM memory is available, you can log all OEM variables as well as your own custom variables.
➡ PROTOCOLS
✅ VAG
SIMOS18.1
SIMOS18.10
✅ PORSCHE
SDI21
⭐ bFlash Master
⭐ bFlash Slave
❗ ECM Titanium Update! ❗
✅ ECM Titanium Drivers Update on Bosch MED17.5.21 and MED17.5.25 equipped on VAG group vehicles.
➡ More information here
❗ bFlash Update V2109A ❗
⭐ bFlash now supports Benelli & CFMoto MSE6.0/US6.0 ECU for all users.
❗ Please note that a specific bench power supply is needed in order to communicate with these ECUs.
✅ The reading time is around 1 minute and 20 seconds.
✅ The writing time is around 20 seconds for a calibration.
✅ NEW BENCH PROTOCOLS
➡ BENELLI
MSE6.0
➡ CFMOTO
MSE6.0
US6.0
bFlash Master
bFlash Slave
⭐️❗️ TGFlash is available on our website! ❗️⭐️
✅ A brand new flasher is available on our website! TGFlash is a tool that does not require a dongle or shipping!
➡️ TGFlash is a complete solution for ECU flash memory reading, virtual reading and reprogramming. Also, TGFlash lets you identify vehicle control units, read & clear DTC.
⭐️ More information here
TGFlash Master
TGFlash Standard
TGFlash Slave
❗️ ECM Titanium drivers updated on Continental SIMOS10 and SIMOS18 ❗️
➡️ ECM Titanium Drivers Update on Continental SIMOS10 and SIMOS18 equipped on Audi, Seat, Skoda and Volkswagen.
✅ MAXIMUM / MINIMUM DIFFERENCE FOR TOO HIGH / LOW ENGINE LOAD
✅ TEMPERATURE DIFFERENCE FOR TURBINE PROTECTION
✅ TURBO
✅ POP&BANG
More information here
ECM Titanium
❗ bFlash Update V2109B - Acura / Honda PGMFI ❗
✅ More support was added for popular Honda vehicles with 2.0L N/A, 2.0L Turbo, 2.4L N/A and 3.5L N/A engines. The 1.5T protocol was also revised and highly improved with reading time reduced from 50 minutes to around 10 minutes.
➡ How fast is it?
The reading time is between 10 and 18 minutes.
The writing time is between 3 and 6 minutes.
➡ How do I connect to the ECU?
You can connect bFlash directly to the OBD socket
NEW OBD PROTOCOLS
✅ ACURA
Keihin PGMFI MPC5566
Keihin PGMFI SH7254x
Keihin PGMFI TC275
Hitachi PGMFI SH72543
✅ HONDA
Keihin PGMFI MPC5566
Keihin PGMFI SH7254x
Keihin PGMFI TC275
Hitachi PGMFI SH72543
⭐ bFlash Master
⭐ bFlash Slave
❗️ Autotuner Update! ❗️
Keihin 37820-5Ax in Honda is supported in Autotuner!
Autotuner is now able to perform the following operations:
✅ OBD Reading
✅ OBD Writing
On the following ECUs:
✅ Keihin 37820-5Ax
➡️ Vehicles involved:
✅ Honda 1.5 i-VTEC
✅ Honda 1.5T VTEC
Autotuner Master
Autotuner Slave
⭐️ Autotuner Update: Bosch EDC16C7 ⭐️
Autotuner is now able to perform the following operations:
✅ Bench Read
✅ Bench Write
➡️ On the following ECU:
✅ Bosch EDC16C7
➡️ Vehicles concerned:
✅ Ford 2.5 TDCI
✅ Ford 3.0 TDCI
✅ Honda 2.2 CDTI
✅ Mazda 2.5 MZR CD
Autotuner Master
Autotuner Slave
❗️ bFlash Update V2110A ❗️
➡️ bFlash now supports SkyActiv-G & SkyActiv-D vehicles equiped with Melco & Denso ECUs via OBD.
Versions with and without crypto are supported.
⭐️ NEW OBD PROTOCOLS
MAZDA DENSO
✅ DCM-S553 - DCM-S553
✅ DCM-SH9V - DCM-SH9V
✅ PCM-PE2L - SH72543
MAZDA MELCO
✅ PCM-P301 - MH8501
✅ PCM-P501 - MH8501
✅ PCM-P51W - MH8501
✅ PCM-PE01 - MH8501
✅ PCM-PE07 - MH8501
✅ PCM-PE7W - MH8501
✅ PCM-PE11 - MH8501
✅ PCM-PE25 - MH8501
✅ PCM-PEAJ - MH8501
✅ PCM-PYFL - MH8501
✅ PCM-PYFA - MPC5746
bFlash Master
bFlash Slave
❗️ K-TAG Update! ❗️
New K-TAG protocols to work in Boot and Service Mode with ECU Bosch equipped on many Link &Co, Mercedes-Benz, Nissan, Renault, and Volvo vehicles
The ECUS Bosch involved are:
✅ BOSCH DCU17PC42
✅ BOSCH EDC15C11
✅ BOSCH ME2.1
✅ BOSCH MG1CS080
More information here
➡️ K-TAG Master
➡️ K-TAG Slave
⭐️❗️ Editing software from the creators of FLEX! ❗️⭐️
An editing software StageX PLUS SW License from MagicMotorSport!
StageX is the remapping software developed by Magicomotorsport. The new Online software in PLUS version includes Map recognition and DTC removal functions at no additional cost. Remapping launched in just a few seconds.
✅ 2D and 3D Visualization
✅ Map Pack Recognition
✅ DTC Removal Module Included
✅ Solution Module
✅ File Project History
✅ Autodetect similar project
➡️ The software requires monthly subscription with a 7-day trial period.
The ECU list is to be expanded.
➡️ Please note: Some requested services may require the help of a Tuner for completion.
✅ StageX PLUS SW License
❗️New BitEdit modules for Isuzu!❗️
✅ BitEdit presents two new modules: Isuzu Delphi and Isuzu Transtron Aurix!
➡️ More information here
❗️ New M&D flasher is open for pre-order! ❗️
License 88 — for Dacia, Lada, Nissan, Renault with EMS3120 / EMS3125 / ValeoV4x: duckduckduckduck OFF
✅ Full flash file read in BSL mode is required for working with this license.
Additional functions:
✅ The checksums are automatically calculated
More information here
The activation files will be sent within a week after 29.11.2021
❗️ ChipTuning PRO releases a module for Toyota! ❗️
✅ Toyota Denso Petrol 5.7i from a third-party developer for Toyota Sequoia, Tundra, Lexus LX570 with 3UR-FE and 3UR-FBE engines 5.7L
➡️ Supported software and more information is here
⭐️❗️ bFlash Update V2111A ❗️⭐️
The new PUBLIC BETA bench protocol provides full access to internal flash and EEPROM memory in the transmissions listed.
✅ Full reading and writing, without opening the TCU.
➡️ NEW BENCH PROTOCOLS
ALPINE
✅ 7DCT300-SH725xx
AUDI
✅ DQ381-SH725xx
✅ DQ500.g3-SH725xx
MERCEDES
✅ VGS-NAG3 SH725xx - (9G-Tronic)
RENAULT
✅ 7DCT300-SH725xx
SEAT
✅ DQ381-SH725xx
SKODA
✅ DQ381-SH725xx
VW
✅ DQ381-SH725xx
✅ DQ500.g3-SH725xx
➡️ bFlash Master
➡️ bFlash Slave